0: Not used (manual setting) 1: UsedĪllows you to confirm the IPv4 address that was used when the machine started up with DHCP.Īllows you to confirm the IPv4 subnet mask setting that was used when the machine started up with DHCP.Īllows you to confirm the IPv4 default gateway setting that was used when the machine started up with DHCP. After downloading is completed, remove the SD card and turn the machine power off and on.Īllows you to confirm and reset the IPv4 address for Ethernet and wireless LAN (802.11): Īllows you to confirm and reset the IPv4 subnet mask for Ethernet and wireless LAN (802.11): Īllows you to confirm and reset the IPv4 default gateway used by the network for Ethernet and wireless LAN (802.11): Īllows you confirm and change the setting that determines whether the IP address is used with DHCP on an Ethernet or wireless (802.11) LAN network. This prevents a software module accessing the NVRAM during the upload.ĭownloads data from an SD card to the NVRAM in the machine. Note: While using this SP mode, always keep the front cover open. Uploads the UP and SP mode data (except for counters and the serial number) from NVRAM on the control board to an SD card. Sets the URL path of the destination for processing calls to the service center. Sets the RCG port number of the destination for processing calls to the service center. Sets the IP address of the RCG (Remote Communication Gate) destination for call processing at the remote service center.
0 kommentar(er)
